Extension And Dismantling Of Sensor (Series Connection) - Panasonic SF2B Series Instruction Manual

2-4-3 Extension and Dismantling of Sensor (Series Connection)

For constructing the series connection, optional sub sensor exclusive for series connection
(SF2B-□SL) and the cable for series connection (SF2B-CSL□) are required.
For constructing the series connection, the following procedure is required.
● Do not lose any screws during extension / dismantling work.
● Furthermore, do not mix emitters and receivers to mount in series connection.
● The packing is attached to the connector of the cable for a series connection.
If the packing is not attached correctly, reattach the packing as shown in the
figure below, and mount to this device. (2.)
<Constructing method for the series connection>
1. Loosen the two M3 screws of the end cap on the main sensor (this device), and then remove
the end cap from the device.
2. Insert the cable for series connection (SF2B-CSL□) into the connector of the main sensor (this
device) and the sub sensor exclusive for series connection (SF2B-□SL). When inserting the
connector, fit the cable into the groove of the main sensor (this device) and the sub sensor
exclusive for series connection (SF2B-□SL).
Connector
3. Tighten each two M3 screws. The tightening torque should be 0.3N·m or less.
When using the bottom cap cable (SF2B-CB05-B) (optional),
make sure that the frequency selector at the insertion slot of
bottom cap cable on this device is set to '1' position (on both
emitter and receiver). If they are in the position other than the
above, the device may not operate properly.
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
End cap
Main sensor (this device)
Connector
Groove
M3 screw
Enclosed with the cable
for sires connection
Bottom of the sub
sensor exclusive
for the series
connection
(SF2B-□SL)
M3 screw
Cable for serial connection
(SF2B-CSL□) (Optional)
Cable
Cable
Bottom of the sub
sensor exclusive
for the series
connection Top of the main sensor
(SF2B-□SL) (this device)
Top of the main sensor
(this device)
Connector
Connector
Frequency selector
25