Cable Specification - Panasonic SF2B Series Instruction Manual

2-5-3 Cable Specification

Connect the mating cable (with connector on one end, or connector on both ends) to the con-
nector of the bottom cap cable which is mounted on this device (emitter and receiver).
Wire the other side of the mating cable according to the customer's application referring to the
connector pin arrangement given below.
● When extending the cable, use the exclusive cable up to the total length of
30.5m (for emitter / receiver). Extending the cable longer than 30.5m may
cause malfunction, which can result in death or serious injury.
● When the synchronization cable is extended with a cable other than exclusive
cable, use a ø 0.2mm
Bottom cap cable / discrete wire
Extension cable with connector on one end
B side
Connector at A side (for emitter / receiver)
<8-core>
<8-core cable (SF2B-CCB□, SF2B-CB□)>
Cable / connector color
Emitter Gray / Gray
Gray (with black stripe)
Receiver
/Black
© Panasonic Industrial Devices SUNX Co., Ltd. 2016
Ramco Innovations | www.ramcoi.com | 800-328-6236 | nsales@ramcoi.com
2
or more shielded twist pare cable.
Bottom cap cable / connector
Extension cable with connector on both ends
B side
Connector at B side (for emitter / receiver)
<4-core> <8-core>
Connector Color code for
Pin No. SF2B-CCB□
1 Pale purple
2
3
4 Yellow-green / Black
5
6 Orange / Black
7
8
1
2
3
4 Yellow-green
5
6 Orange / Black
7
8
Brown
Pink
Auxiliary output (AUX)
Orange Synchronization +
Blue
(Shield)
White Control output 2 (OSSD 2)
Brown
Black Control output 1 (OSSD 1)
External device monitor input
Orange Synchronization +
Blue
(Shield)
A side
A side
<4-core>
Description
Not connected
+V
Test input
Synchronization -
0V
-
+V
Synchronization -
0V
-
37