Huawei IRD6000 User Manual page 20

IRD6000
User Guide
Step 2 Set the parameters for the main board.
Parameter settings related to signal reception and program search are available on the
configuration interface for the main board, as listed in Table 2-3.
Table 2-3 Main board parameters
Parameter
Satellite IRD tuner
Source
LNB Frequency
Satellite
Frequency
Symbol rate
LNB Voltage
LNB 22KHz
Ground IRD tuner
Bandwidth
Frequency
Cable IRD tuner
Constellation
Symbol rate
Frequency
Signal level
Universal settings
Issue 02 (2012-12-05)
Description
Selects the program source.
According to the source the signals received, select TUNER, ASI, or
IPTV.
The local frequency of the LNB on the antenna, normally marked on
the LNB.
Transmission frequency of the satellite signals to be received.
Range supported by the IRD6000: 950–2150 MHz
Symbol rate of satellite programs.
Information about the symbol rate is available on the satellite program
list provided by the program provider.
Supply voltage for the LNB
The LNB requires different supply voltages (vertical 13 V or
horizontal 18 V) when receiving programs in different bands (C band
or Ku band). The IRD6000 supplies the voltages.
Controls the 22 kHz switch.
This parameter applies to dual local frequency LNBs for the Ku band
in particular. ON indicates high local frequencies, and OFF indicates
low local frequencies.
Selects the frequency bandwidth (6 MHz/7 MHz/8 MHz).
Enters the ground signal transmission frequency.
Range supported by the IRD6000: 174–230 MHz, 474–858 MHz
QAM (16/32/64/128/256)
3–7 Mbit/s
Enters the cable signal transmission frequency.
Range supported by the IRD6000: 50–862 MHz
–105 dBuV to +32 dBuV
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Operation Instructions
15