Hitachi YUTAKI S Series Technical Catalogue page 117

9 Electrical and control settings
General check
• The status of Harmonics for each model, regarding compliance with IEC 61000-3-2 and IEC 61000-3-12, is as
follows:
Status regarding
compliance with
IEC 61000-3-2 and
IEC 61000-3-12
Equipment complying with
IEC 61000-3-2
(*): Professional use
Equipment complying with
IEC 61000-3-12
Installation restrictions
may be applied by supply
authorities in relation to
harmonics
• Check to ensure that existing installation (mains power switches, circuit breakers, wires, connectors and wire
terminals) already complies with the national and local regulations.
• The use of the DHW tank heater is disabled as factory setting. If it is desired to enable the DHW tank heater
operation during normal indoor unit operation, adjust the DSW4 pin 3 of the PCB1 to the ON position and use the
adequate protections. Refer to the section
109 TCGB0123 rev.2 - 10/2019
Split system
Outdoor unit
YUTAKI S
RAS-2WHVRP(*) RWM-2.0NRE(-W)
RAS-2.5WHVRP(*) RWM-2.5NRE(-W)
RAS-3WHVRP (*) RWM-3.0NRE(-W)
-
-
"9.3 Electrical connection"
Models
Indoor unit
YUTAKI S COMBI
-
RWD-2.0NRWE-200S(-W)
RWD-2.0NRW(S)E-260S(-W)
RWD-2.5NRWE-200S(-W)
-
RWD-2.5NRW(S)E-260S(-W)
RWD-3.0NRWE-200S(-W)
RWD-3.0NRW(S)E-260S(-W)
- -
for the detailed information.
Monobloc system
YUTAKI M
RASM-2VRE (*)
RASM-3VRE(*)
-
-
9