Cleaning Mode - Lenovo T1 User Manual

Instructions
Long press button for power-on. The indicator of the button
turns on slowly, and the machine gets in standby state. When
The white light slowly extinguishes, and the cleaning is over.
Note: The machine cannot shut down during charging.
Pause
When the machine is running, press any button to pause. If
pressing again after pause, the machine will continue to clean,
Press button and the machine will go to charge and end the
cleaning. Press button and the machine will execute partial
cleaning.
Note: If charging the machine by moving it to the charger base
during the pause, the cleaning will be ended.
Charge
Automatic mode: After cleaning, the machine will automatically
find it way to charge.
Manual mode: In pause state, press
When the machine is charging, the orange indicator of the power
button is always on. The white breathing indicator will be on when
the battery is full.
Note: If the machine does not start cleaning from the charging
base or dust collector, auto-charging may fail because the
machine will automatically return to the position where it starts.
Please manually put the machine back to the charging base or
dust collector for charging.

Cleaning mode

After cleaning starts, the machine will scan the room, generate
a map and zone the room intelligently. In the zoning, it will firstly
clean along the wall, plan the sweeping path and then clean
each zone one by one in zigzag, and cover all zones in an orderly
return to the charging base for charging.
button to start charging.
Whole house cleaning
Press the button to start the whole house cleaning
(see the picture of cleaning route as below).
Press any button to pause while cleaning.
Area 1 has been Area 2 has been
cleaned up cleaned up
Area 4 is to be Area 3 is being
cleaned cleaning
Note:
It is recommended that the vacuum robot start the
cleaning from the charging base or dust collector.
If the power is too low to start the whole house
cleaning, please charge it first and then start the
whole house cleaning.
machine will automatically return to the charging base
point to continue cleaning when the battery is fully charged.
Please tidy up all kinds of wires (power lines) on the ground
before cleaning, so as to avoid outage and damage to articles
or wires caused by the machine dragging when cleaning.