Lenovo T1 User Manual page 24

FAQ
Fault prompt
Fail to return to the charging base
Abnormal behavior
Abnormal noise occurs when cleaning
Decrease in cleaning capacity or dust leakage
Fail to connect to WiFi
Whether the machine consumes electricity if it
stays at the charging base all the time
Is it necessary to charge the machine for 16
hours for the first three times of cleaning?
mopping module
mopping module
Return for charging during cleaning but never
continue cleaning
Failure to return to the charging base after
Resolution
There are too many obstacles near the charging base. Please put the charging
base in an open area.
The machine is too far from the charging base. Please put the machine near
the charging base and retry.
Reboot the machine.
Main brush, side brush or main wheel may be twisted with foreign matters.
Please shut down and clean.
The dust box is full, please clean it.
The filter screen has been blocked, please clean it.
The main brush is twisted by foreign matters, please clean it.
Poor WiFi signal. Please make sure that the machine is in an area with good
Wi-Fi signal coverage;
Abnormal WiFI connection. Please download the latest client, reset WIFI and
try connecting again.
Wrong WIFI password. Please reconfirm if the password is correct.
power is more than 30%.
When the machine is on the charging base, the power consumption is
extremely low. It is conducive to maintaining the best performance of the battery.
battery is fully charged. Not necessary to wait for 16 hours.
Please check whether the water tank cover is in place. Clean the mop.
Change the filter element. Install the mop correctly according to the instruction.
Please make sure that the water tank cover and the filter element are
installed in place.
Please make sure that the machine is not in the Do-not disturb Mode. When in
the Do-not disturb Mode, the machine will not continue cleaning. Manual charging
or putting the machine back to the charging base will not continue cleaning.
After partial cleaning or moving the position of the machine far away, the machine
will regenerate the map, such as the charging base.
If it is too distant, the machine may not be able to return to the charging base
automatically. Please manually put the machine back to the charging base for charging.