Sony UP-DF550 Manual page 42

Notes
• When you put your hands inside of the unit, be careful
not to hurt yourself by touching hot or sharp parts.
• If you turn off the power, image data that has not been
printed yet is cleared.
When REMOVE FILM TRAY 1 or REMOVE FILM
TRAY 2 appears
1
Remove the corresponding film tray.
When the unit is not turned on, you can pull the film
tray out without pushing the EJECT TRAY button.
Notes
• If any printouts have been ejected onto the film
tray, remove them first before removing the film
tray.
• When you pull out the film tray, hold both sides
of the film tray and the tray cover with both
hands.
2
Remove jammed film according to the status
displayed.
When a film sheet pops out from the shutter
of the feeding position of the film tray:
Remove the jammed film sheet slowly while
holding the film with both hands.
Do not reuse the removed film. Discard it.
42
Troubleshooting
When a film sheet is jammed between the
feeding position and the shutter of the film
tray:
Put it back in the film tray.
When a film sheet is jammed inside the
unit:
Remove the jammed film sheet slowly while
holding the film sheet with both hands.
Do not reuse the removed film. Discard it.
3
Re-insert the film tray as it was.
When placing the unit vertically
Pay attentions to the following points when you remove
or insert the film tray with the unit placed vertically.
• Do not give a shock to the film tray. Doing so may
cause the film sheets will move inside the film tray.
This may result in the film jamming.
• When removing or inserting the film tray, hold it by
pushing the cover with both hands. If you hit the film
tray, the cover of the film tray will open and the film
sheets may pop out.
• If you slant the film tray, the film sheets may move to
the outlet of the film tray. This may cause film
jamming. In such a case, put the film sheets back