Table of Contents
Advertisement
Pair mode and single mode
Pair mode
Enabling pair mode allows you to link operation of a pair
of FM outputs. For example, performing an operation,
such as a freeze, on FM1 will perform the same operation
on FM2.
The image data saved in pair mode is referred to as a "pair
file." In a pair file, the image data processed on the odd-
numbered FM output is the main file, and the image data
processed on the even-numbered FM output is the sub file.
Only pair files can be selected when performing frame
memory operations in pair mode.
Single mode
In single mode (pair mode disabled), you can perform
operations on a pair of FM outputs independently.
The image data saved in single mode is referred to as a
"single file."
Both single files and pair files can be selected when
performing frame memory operations in single mode.
Selecting a pair file will recall the main file only on the FM
output.
V/K mode
When V/K mode is enabled, selecting a signal on the frame
memory source 1 bus will automatically select the paired
key signal on the frame memory source 2 bus.
Files and folders
In frame memory, files are stored and managed in folders
you create.
The names of folders can comprise up to 16 characters, and
the names of files can comprise up to 32 characters.
Notes
• The created folder hierarchy can have up to three levels
below the root level.
• The following names cannot be used for files/folders.
CON, PRN, AUX, CLOCK$, NUL
COM0, COM1, COM2, COM3, COM4, COM5, COM6,
COM7, COM8, COM9
LPT0, LPT1, LPT2, LPT3, LPT4, LPT5, LPT6, LPT7,
LPT8, LPT9
• When a file name is too long to be displayed in full, ".."
is displayed after the name.
Frame Memory
Operations
Preparations
Assigning the frame memory outputs (FM1
to FM20) to cross-point buttons
To output a frame memory image to a monitor, for
example, the output signal from the frame memory (FM1
to FM20) must be assigned to a cross-point button. The
assignment is configured in the Setup menu.
159
Advertisement
Table of Contents
