Table of Contents
Advertisement
To set the playback stop point
To make the current position the playback stop point, press
the [STOP TC] button.
To repeat playback (looping)
Press the [FM LOOP] button.
To control variable speed playback
Press the [JOG], [SHTL], or [VAR] button, then turn the
Z-ring. The image changes in the forward direction when
you turn the Z-ring clockwise, and in the reverse direction
when you turn it counterclockwise.
When the [JOG] button is pressed: Playback is at a
speed corresponding to the turning speed of the Z-ring.
When the [SHTL] button is pressed: Playback is at a
speed corresponding to the angle of the Z-ring.
When the [VAR] button is pressed: Playback is at a
speed in the range –1 to +3 times normal speed
corresponding to the angle of the Z-ring.
Clip Transitions
You can play a frame memory clip linked to a background
transition, such as a mix or wipe.
Only eight channels comprising FM1 to FM8 (FM1&2
Clip, FM3&4 Clip, FM5&6 Clip, FM7&8 Clip) can be
used in a clip transition.
Clip transition restrictions
• Pattern limits cannot be used.
• Transition preview cannot be used.
• It is not possible to set the transition rate of a clip
transition.
• Keyframe capture is not possible.
• The state of a clip transition during execution cannot be
saved as a snapshot.
• When recalling a snapshot that includes a clip transition
while executing another clip transition, the subsequent
transition does not operate properly. Recall the snapshot
after the transition completes.
• Transitions executed in two strokes, such as a preset
color mix with the stroke mode set to [Normal], or a
DME wipe with a picture-in-picture pattern, will not
execute correctly.
Note
When a clip transition is selected as the transition type, the
wipe direction selection button in the transition control
block that is lit indicates the direction of clip playback.
Clip Transition Settings
This section describes clip transitions using FM1&2 Clip
on the M/E-1 bank as an example.
Note
To use a clip transition effectively, the image from the
frame memory clip image that is played back during the
clip transition must be reflected in the M/E-1 program
image beforehand. For example, the settings for inserting
a key using FM1 and FM2.
1
In the <Transition Type> group of the M/E-1 >Misc
>Transition menu (1171), select [FM1&2 Clip].
2
Press [Clip Transition].
The Clip Transition menu (1176) appears.
3
Press [Clip >Recall].
The Frame Memory >Clip/Still >Recall menu (2111)
appears.
166
Advertisement
Table of Contents
