Recommended Maintenance Schedule(S) - Toro Workman GTX Series Operator's Manual

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 5 hours
After the first 8 hours
After the first 50 hours
After the first 100 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 300 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Yearly
Note:
Download a free copy of the electrical schematic by visiting www.Toro.com and searching for your
machine from the Manuals link on the home page.
Important:
Refer to your engine owner's manual for additional maintenance procedures.
Maintenance Procedure
• Change the engine oil.
• Check the condition of the drive belt.
• Check the tension of the starter-generator belt.
• Check the air filter for the carbon canister.
• Perform the guidelines for breaking in a new machine.
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the tire pressure.
• Check the engine-oil level.
• Check gear-shift operation.
• Check the brake-fluid level.
• Wash the machine.
• Remove the air-cleaner cover and clean out the debris. Do not remove the
air-cleaner element.
• Clean out the debris in the dust cap.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—replace the air-cleaner element. Replace the air-cleaner
element sooner if dirty or damaged.
• Under special operating conditions (refer to Maintaining the Machine under Special
Operating Conditions)—change the engine oil.
• Grease the bearings and bushings.
• Under normal operating conditions—replace the air-cleaner element. Replace the
air-cleaner element sooner if dirty or damaged.
• Under normal operating conditions—change the engine oil.
• Check the spark plug.
• Check the condition of the tires and rims.
• Torque the wheel-lug nuts.
• Inspect the steering and suspension for loose or damaged components.
• Check the front wheel camber and toe-in.
• Check the transaxle-fluid level.
• Check the operation of the neutral gear-shift position.
• Clean the engine-cooling areas.
• Inspect the brakes.
• Check the air filter for the carbon canister.
• Check the condition and tension of the drive belt.
• Check the tension of the starter-generator belt.
• Grease the front wheel bearings.
• Inspect the fuel lines and connections.
• Replace the fuel filter.
• Clean the primary drive clutch.
• Replace the service and parking-brake pads.
• Change the transaxle fluid.
• Change the brake fluid.
• Complete all of the yearly maintenance procedures that are specified in the engine
owner's manual.
25