Toro Workman GTX Series Operator's Manual page 32

Figure 31
1. Spindle
7. Wipe clean the spindle with a rag.
8. Repeat steps 1 through
the other side of the machine.
g192347
2. Hub and rotor assembly
7 to the hub and rotor at
Greasing the Wheel Bearings
1. Remove the outboard bearing and bearing race
from the hub (Figure
1. Seal
2. Inboard bearing
3. Inboard-bearing race
2. Remove the seal, inboard bearing from the hub
(Figure 32).
3. Wipe clean the seal and check for wear and
damage.
Note:
Do not use cleaning solvent to clean the
seal. Replace the seal if it is worn or damaged.
4. Clean the bearings and races, and check these
parts for wear and damage.
Note:
Replace all worn or damaged parts.
Ensure that the bearings and races are clean
and dry.
5. Clean the cavity of the hub of all grease, dirt,
and debris (Figure
6. Pack the bearings with the specified grease.
7. Fill the cavity of hub 50 to 80% full of the
specified grease
8. Assemble the inboard bearing onto the race at
the inboard side of the hub and install the seal
(Figure 32).
9. Repeat steps
other hub.
32
32).
Figure 32
4. Bearing cavity (hub)
5. Outboard-bearing race
6. Outboard bearing
32).
(Figure 32).
1 through 8 to the bearings for the
g033050