Table of Contents
Advertisement
5.
Loosen the jam nuts securing the proximity
switch to the frame and lower the switch until
it is 2.6 to 4.0 mm (0.10 to 0.16 inch) from the
sensing plate on the hitch tongue
Tighten the jam nuts to secure the adjustment.
1. Proximity switch
2. Jam nut
3. 2.6 to 4.0 mm (0.10 to 0.16
inch)
4
Installing the Hydraulic
Cylinder
Parts needed for this procedure:
1
Rear actuator tab
4
Bolt (1/2 x 2 inch)
8
Flat washer (0.531 x 0.063 inch)
4
Locknut (1/2 inch)
2
Bolt (3/8 x 1-1/4 inch)
2
Pin assembly
2
Flange nut (3/8 inch)
Procedure
1.
Mount the rear actuator tab to the machine
frame with 4 bolts (1/2 x 2 inch), 8 flat washers
(Figure
Figure 4
4. Sensing plate
5. Hitch tongue
(0.531 x 0.063), and 4 locknuts (1/2 inch).
Position the components as shown in
4).
1. Rear actuator tab
2.
Secure each end of the hydraulic cylinder to an
actuator tab with a pin assembly, a bolt (3/8 x
1-1/4 inch), and a flange nut (3/8 inch)
g011587
Note:
of the cylinder is attached to the front actuator
tab.
1. Front actuator tab
2. Rear actuator tab
11
Figure 5
2. Machine frame
Make sure that the rod end (working end)
Figure 6
3. Hydraulic cylinder
4. Pin assembly
Figure
5.
g011261
Figure
6).
g011260
Advertisement
Table of Contents
