Table of Contents
Advertisement
•
On Workman models with serial numbers prior to
899999999, the harness has power.
•
On Workman models with serial numbers
900000001 and up, turn the ignition key to the
position to power the harness.
1. Controller
Using the Controller
Timeout Feature
The machine is equipped with a timeout feature for the
control module. The timeout feature is activated after
2-1/2 hours of continuous remote transmitter inactivity.
•
When in the timeout mode the remote transmitter
does not control any function.
•
To wake the controller in timeout mode:
– On Workman models with serial numbers prior
to 899999999, unplug and plug the machine
harness into the vehicle power harness.
– On Workman models with serial numbers
900000001 and up, turn the ignition key to the
position and back to the
OFF
•
To avoid controller timeout during operation, use
the remote transmitter to offset the machine at
least every 2-1/2 hours.
Using the Hopper Safety
Support
Whenever you work under the raised hopper, ensure
that the hopper safety support is installed onto the
extended lift cylinder.
1.
Raise the hopper until the lift cylinder is
extended.
2.
Remove the hairpin cotter and pin securing the
safety support to the storage bracket on the
machine frame
(Figure
support.
Figure 25
position.
RUN
26). Remove the safety
RUN
g030472
1. Hopper-safety support
2. Storage bracket
3.
Insert the hopper-safety support onto the
cylinder rod, making sure the support end rests
against the cylinder barrel and the cylinder-rod
end
(Figure
Note:
Secure the hopper safety support to the
cylinder rod with the hairpin cotter and pin.
1. Safety support
4.
To store the safety support, remove the safety
support from the cylinder and secure it to the
storage bracket on the machine frame.
5.
Always install or remove the safety support from
behind the hopper.
Important:
Do not try to lower the hopper with
the safety support on the cylinder.
24
Figure 26
3. Pin
27).
Figure 27
g011020
g011021
Advertisement
Table of Contents
