Table of Contents
Advertisement
Replacing the Remote
Batteries
The handheld remote is powered by 4 AAA batteries.
When installing batteries, observe proper polarity as
marked on the inside of the compartment to avoid
damaging the unit.
1.
Remove the 6 screws from the back of the
remote and remove the cover
Note:
If possible, leave the rubber seal and
steel gasket in the channel when removing the
cover and batteries.
Figure 40
1. Screw
2. Cover
3. Seal
2.
Remove the discharged batteries and properly
dispose in accordance with local regulations.
3.
Plug each fresh battery into a terminal cradle
observing proper polarity.
Note:
If the batteries are improperly installed,
the unit will not be damaged, but it will fail to
operate.
4.
If you accidentally removed the rubber seal and
the steel gasket, replace them carefully into the
channel in the handheld remote.
5.
Replace the cover and secure it with the 6
screws removed previously
torque them to 1.5 to 1.7 N∙m (13 to 15 in-lb).
Note:
Do not overtighten the screws.
(Figure
40).
g029817
4. Steel gasket
5. Batteries
6. Handheld remote
(Figure
40) and
Storage
1.
Thoroughly clean the machine so that it is free
of dirt, leaves, and debris.
2.
Check the tire pressure. Refer to
Tire Pressure (page
3.
Check all fasteners and tighten them as
necessary.
4.
Grease all the grease fittings. Wipe off any
excess lubricant.
5.
Check the condition of the brush and replace it
if necessary.
33
Checking the
23).
Advertisement
Table of Contents
