Default Settings In The Scsi Setup - Siemens D981 Technical Manual

SCSI Setup

Default Settings in the SCSI setup

SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Additional Options
Boot Device Options
Boot Target ID
Boot LUN Number*
SCSI device configuration ( for each SCSI device)
SCSI device ID
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable disconnection
Initiate wide negotiation
Send Start Unit Command**
Include in BIOS Scan
Advanced Configuration Options
Reset SCSI Bus at IC Initialization
Host Adapter BIOS
Support Removable Disks Under BIOS as
Fixed Disks**
Extended BIOS Translation for DOS Drives
>1 Gbyte**
>&WUO@ >&WUO@
Display
Initialization**
Multiple LUN Support**
BIOS Support for Bootable CD-ROM**
BIOS Support for Int 13 Extensions**
Support for Ultra SCSI Speed
* The setting is valid only if
** The setting is valid only if SCSI controller BIOS is
A26361-D981-Z120-9-7419
>$@ >$@
- Message During BIOS
Multiple LUN Support
Default Settings in the SCSI setup
Default setting
7
Enabled
LowON/HighON
Default setting
0
0
1 to 15
Yes
40 Mbyte/s
Yes
Yes
Yes
Yes
Default setting
Enabled
Enabled
Boot only
Enabled
Enabled
Disabled
Enabled
Enabled
Enabled
enabled
is .
Enabled
.
English - 21