Dismantling The Product; Inserting / Replacing Batteries In The Remote Control; Initial Use - Silvercrest 9000 BTU Operation And Safety Notes

provided on the back air outlet
(see fig. E).
7
Place the window feed-through
with the side indicated by the
arrow in Figure G facing outwards
towards the window opening.
Adjust the length of the window
feed-through
12
sponds to the width or height of
the window (see fig. F). To do
this, insert the two parts of the
window feed-through
each other. The window feed-
through can be adjusted as
12
required between 67.5 cm and
123 cm.
Fix the movable part of the win-
dow feed-through
fixing plug (see fig. G).
16
Close the window so that it directly
contacts the window feed-through
and fixes it in place.
12
Insert the hose connector (win-
dow) into the round opening
14
of the window feed-through
so that it locks firmly into place
(see fig. H).

Dismantling the product

To disassemble the product, re-
peat the process in the reverse
order.
12
so that it corre-
into
12
using a
12
12
Note: Drain the water tank as
described in the chapter "Drain-
ing the water tank".
Inserting / replacing
batteries in the remote
control
Open the battery compartment
cover on the back of the re-
30
mote control
Remove any used batteries from
the battery compartment.
Insert 2 AAA (LR03) type batter-
ies into the battery compart-
29
ment. Make sure that the polarity
(+ or -) is correct as indicated in
the battery compartment.
Reattach the battery compart-
ment cover
30
compartment.

Initial use

Note: The product has 3 operating
modes: cooling mode, dehumidifi-
cation mode and fan mode.
Unless otherwise described, you can
select all the settings listed below
using both the control panel
the remote control
Each time a button is pressed, an
acoustic signal sounds as confir-
mation.
(see fig. K).
11
to the battery
and
1
(see fig. B or C).
11
GB/IE 39