Troubleshooting - Silvercrest 9000 BTU Operation And Safety Notes

of the opening and allow the
water to drain (see fig. I).
Connect a suitable drainage hose
(not included) to the opening.
Place the open end of the drain
hose in a suitable collecting vessel
or drain.
Make sure that the drain hose
leads to the drain as directly
as possible and without kinks
or knots. This way, the water
collected during the dehumidifi-
cation process is automatically
fed into the drain.

Troubleshooting

Problem
The product
won't start.
The product
is not cooling
sufficiently.
Possible cause
The water tank is full.
The room temperature is
lower than the set tempera-
ture (cooling mode).
Doors and windows are
not closed properly.
There are heat sources in
the room.
The hot air outlet hose
not connected or blocked.
The temperature setting is
too high.
The air inlets ,
5
blocked.
Some errors are caused by minor
malfunctions and can sometimes be
corrected by the user. If you are still
unable to remedy the problem, con-
tact customer service. Do not repair
the product yourself under any cir-
cumstances.
Solution
Empty the water tank.
Adjust the temperature
setting.
Close doors and windows.
Remove all heat sources
if possible.
Connect the hot air outlet
is
13
hose
Adjust the temperature
setting.
are
Clean the air inlets
9
or clean it.
13
,
5
GB/IE
.
9
43