Adjusting The Air Flow; Draining The Water Tank; Using Continuous Water Drainage - Silvercrest 9000 BTU Operation And Safety Notes

will be cancelled after about
10 seconds. The timer will start
counting down the remaining time
and the product will turn off au-
tomatically when the time is up.
To cancel the timer function, press
the TIMER button

Adjusting the air flow

You can adjust the air flow man-
ually by moving the ventilation
slots on the front air outlet
2
up or down.

Draining the water tank

The integrated water tank fills
with water in the following
situations:
– At low room temperature and high
humidity, the product may not be
able to evaporate the moisture
quickly enough. If this is the case,
water collects in the water tank.
– If the product is in dehumidification
mode, it draws moisture from the
air in the room. Consequently,
water accumulates in the water
tank. When the water tank is full,
the water tank indicator (W.F)
lights up and the error code "E2"
is shown on the display
product stops operating.
42 GB/IE
Proceed as follows to drain
the water tank:
once.
22
3
If the product is mainly being used
in dehumidification mode, it is pos-
sible to drain the water continuously
and thus empty the water tank au-
tomatically.
17
. The
20
Switch off the product and
remove the mains plug
the socket.
Pull the hose connector
back air outlet
7
the hot air outlet hose
the product.
Take the product to a place where
water can drain properly.
Pull the drain plug
as the inner plug beneath it) out
of the opening and allow the
water to drain (see fig. I).
Insert both drain plugs
into the opening properly. Once
the product has been connected
to the power supply and the hot
air outlet hose
13
tached, it can resume operation.
Using continuous
water drainage
Switch off the product and remove
the mains plug
10
Pull the drain plug
as the inner plug beneath it) out
from
10
off the
15
and remove
from
13
(as well
8
back
8
has been reat-
from the socket.
(as well
8