Siemens SIMOCODE pro V Manual page 32

3 Engineering
–
Diagnostics
The STEP 7 project does not contain a controller, as the controller is not part of
Note
the core contents of the application example. Integrating and networking a
controller is the user's responsibility in this project. It should be noted here that
the stall prevention logic can be used independently of the bus system that you
use, i.e. it can also be used with the PROFIBUS or MODBUS RTU variant of the
SIMOCODE pro V.
Because the SIMOCODE device is not networked with a controller, it also
appears in the project tree under "Unassigned devices" and is marked as "Not
assigned" in the Network view.
Blocking Protection for Pumps with SIMOCODE pro V
Article ID: 109478058, V2.0, 09/2020
32