Sony DNE-1000 Maintenance Manual page 10

1-4. Input and Output Signals of Connectors
n
(*1) <Controller> : indicates a controlling device.
(*2) <Device> : indicates a controlled device.
(*3) : Based on the Ethernet 10 BASE-5
(*4) : Based on the RS-232C
(*5) : Based on the RS-422A
GUI : Ethernet 10 BASE-5
Pin No. Signal name Function
1 GND Ground
2 ECD+ Collision-detection (+)
3 ETX+ Transmitted data (+)
4 –– ––
5 ERX+ Received data (+)
6 COMMON Common ground
7 –– ––
8 –– ––
9 ECD_ Collision-detection (_)
10 ETX_ Transmitted data (_)
11 –– ––
12 ERX_ Received data (_)
13 +12 V Power supply +12 V
14 –– ––
15 –– ––
RS232C : RS-232C (*4)
(D-sub 9-pin Male)
(*1)
<Controller>
Pin No. Signal name Function
1 –– ––
2 RXD Received data
3 TXD Transmitted data
4 –– ––
5 GND Ground
6 –– ––
7 RTS Request to send (Output)
8 CTS Clear to send (Input)
9 –– ––
1-4(E)
(*3)
(D-sub 15-pin Female)
DEVICE CONTROL from A to J
RS-422A
<Device> (*2) from VTR, data servier and local strage
(MAV-500) etc..
Pin No. Signal name Function
1 GND Ground
2 CTLA RXA Received data (_)
3 CTLA TXB Transmitted data (+)
4 GND Ground
5 –– ––
6 GND Ground
7 CTLA RXB Received data (+)
8 CTLA TXA Transmitted data (_)
9 GND Ground
(*6) : When BKNE-1030 (IF-609 board) is attached to
DNE-1000, it is possible to use the DEVICE
CONTROL from E to J.
PANEL : RS-422A (*5)
(D-sub 15-pin Female)
(*2)
<Device> from control panel BKNE-1010.
Pin No. Signal name Function
1 GND Ground
2 PANEL RXB Received data (+)
3 PANEL RXA Received data (_)
4 PANEL TXB Transmitted data (+)
5 PANEL TXA Transmitted data (_)
6 –– ––
7 –– ––
8 GND Ground
9 GND Ground
Data for level meter +
10 METER+
11 +12 V Power supply +12 V
12 METER_ Data for level meter _
13 +12 V Power supply +12 V
14 +12 V Power supply +12 V
15 GND Ground
(*7) : The meter signals of the pin numbers 10 and 12 are
used for BKNE-1011.
(* * * * * 6)
:
(*5)
(D-sub 9-pin Female)
(*7)
(*7)
DNE-1000