Sony DNE-1000 Maintenance Manual page 33

S1 (A3) :
This switch is a 8-pin dip switch and is used for the
factory-adjustment.
Setting under normal status ; All OPENs
OPEN
1 2 3 4 5 6 7
S100 "RST" (A6) : System reset
This switch is used for the factory-adjustment.
Do not use.
S101 "C" (A6) : C-CPU break
This switch is used for the factory-adjustment.
Do not use.
S401 "TEST "(A6) : Test
This switch is used for the factory-adjustment.
Do not use.
S501 "D0" (A7) : D-CPU0 break
This switch is used for the factory-adjustment.
Do not use.
S601 "D1" (A7) : D-CPU1 break
This switch is used for the factory-adjustment.
Do not use.
S701 "E" (A7) : E-CPU break
This switch is used for the factory-adjustment.
Do not use.
S801 "D" (A8) : P-CPU break
This switch is used for the factory-adjustment.
Do not use.
DNE-1000
8
1-9. Switch Settings on Boards and LEDs Description
3. IO-122 board
CN4 (A4) : Confirmation of +5 V voltage
This connector is used to measure the +5 V voltage.
CN5 (A5) : GND
This connector is used when measuring.
4. VIF-12 board
CN5
CN4
CN8
D105
D104
D103
(A side/component side)
CN4 (A4) : Confirmation of +5 V voltage
This connector is used to measure the +5 V voltage.
CN5 (A3) : Confirmation of _5 V voltage
This connector is used to measure the _5 V voltage.
CN8 (A5) : GND
This connector is used when measuring the voltage.
D103 (Green) (A7) : Ref. in
When receiving the reference signal, this LED lights.
D104 (Yellow) (A6) : 525/625 system mode
When selecting to the 625 system, this LED lights.
D105 (Red) (A6) : Ref. err
When the receiving reference signal is abnormal, this
LED lights.
1-27(E)