To Replace The Gear Oil - Husqvarna DM 200 Workshop Manual

6.4 To replace the gear oil

Replace the gear oil for the first time after 100 hours of
operation. After that, the interval is approximately each
300 hours of operation.
1. Attach the machine holder tool to a vise. Refer to
Servicing tools on page 6 . Put the product in a
vertical position with the drill spindle in the machine
holder tool.
2. Remove the 4 screws that hold the motor housing.
Put 2 flat screwdrivers in the recesses on the gear
housing. Carefully loosen the middle cover and the
motor housing.
14 - Repair and servicing
CAUTION: Make sure that the O-ring is not
damaged.
3. Remove the middle cover and the motor housing.
4. Put a container below the product. Remove the
product from the machine holder tool. Tilt the
product to drain the gear oil. Fill the gear housing
with new gear oil. Refer to
5. Assemble the product in opposite sequence.
6.4.1 To replace the gear oil seal
1. Remove the middle cover. Refer to
the product on page 10 .
2. Put the point of a screwdriver on the shaft seal (A).
Carefully put pressure on the shaft seal and push it
with the washer (B) in front of it. Remove the shaft
seal and the washer.
A
B
CAUTION: Make sure that the metal surface
does not become damaged.
Servicing tools on page 6 .
To disassemble
1332 - 001 - 04.03.2021