Table of Contents
Advertisement
6.6.4 To replace the shaft sleeves for the drill
spindle
1. Clean the drill spindle shaft with a cloth. Examine
the drill spindle for damage or wear. Refer to
a check of the gear housing and gears on page 31 .
2. Push the 2 shaft sleeves off the drill spindle shaft
with the separator puller tool and a mandrel press.
Servicing tools on page 6 .
Refer to
18 - Repair and servicing
3. Put the first shaft sleeve into the sleeve press tool.
Refer to
shaft sleeve onto the drill spindle shaft with the
mandrel press.
To do
4. Turn the sleeve press tool to the other side. Put the
second shaft sleeve into the sleeve press tool. Push
the second shaft sleeve onto the drill spindle shaft
with the mandrel press.
Servicing tools on page 6 . Push the first
1332 - 001 - 04.03.2021
Advertisement
Table of Contents
