Troubleshooting - Philips Lumea SC1999 Manual

English
18
Rated 'requency
Rated input
Protection a'ainst electric shock
Protections ratin'
Operatin' conditions
Spectrum o' body attachment
Spectrum o' 'acial attachment
Spectrum o' bikini area attachment

Troubleshooting

Problem
The device/adapter
becomes warm durin' use
When I place the device on
the skin it does not release
a 'lash. The ' ready to 'lash
li'ht blinks oran'e and
then li'hts up oran'e
continuously.
The 'ready to 'lash li'ht'
doesn't li'ht up when I
place the attachment on
my skin, but the coolin' 'an
works.
The 'ready to 'lash li'ht'
li'hts up white but the
device does not produce a
'lash when I press the 'lash
button.
I cannot increase or
decrease the li'ht intensity
settin's/All intensity li'hts
are blinkin' alternately
This chapter summarizes the most common problems you could encounter
with the device. I' you are unable to solve the problem with the in'ormation
below, visit www.philips.com/support 'or a list o' 'requently asked questions
or contact the Consumer Care Center in your country.
Possible cause
This is normal.
You skin tone in the area to
be treated is too dark.
The overheat protection has
been activated.
The device needs to be reset. To reset the device, switch it o'' and
The device needs to be reset. To reset the device, switch it o'' and
50Hz-60Hz
36W
Class II
IP 30 (EN 60529)
Temperature:+15 ºC to 35 °C
Relative humidity: 30% to 95%
>530nm
>600nm
>530nm
Solution
No action required.
Treat other body areas with li'hter skin
tones with Lumea.
When the overheat protection has been
activated, the 'an still works. Do not
switch o'' the device, but let it cool down
'or approx. 15 minutes be'ore you
continue to use it.
switch it on a'ain.
switch it on a'ain.