After The Installation Of The Product; Product Settings; Automower ® Connect App - Husqvarna AUTOMOWER 420 Operator's Manual

7. Put the boundary wire or the guide wire into
position with stakes.
8. Connect the charging station to the power outlet.

3.9 After the installation of the product

3.9.1 To do a visual check of the charging
station
1. Make sure that the indicator LED lamp on the
charging station has a green light.
2. If the indicator LED lamp does not have a green
light, do a check of the installation. Refer to
install the charging station on page 20 and
Indicator lamp in the charging station on page 45 .
3.9.2 To do the basic settings
Before the product starts to operate for the first time, you
must do the basic settings.
1. Put the product in the charging station.
2. Switch on the product.
3. Push the arrow buttons and the OK button. Select
language, country, date, time and set a PIN code.
Note:
For some models, a factory PIN code is
necessary before you select a personal PIN code.
It is not possible to use 0000 as PIN code.
4. Push the Start button and close the hatch to initiate
a calibration process of the product.
Note:
If the battery is too low, the product needs
to charge the batteries fully before the calibration
starts. Refer to Calibration on page 23 .
1201 - 005 - 19.03.2021
Note:
Make a note of the PIN code. Refer to
Introduction on page 3 .
3.9.3 Calibration
The calibration process is automatic. After the basic
settings are done, the product moves away from the
charging station and stops, while it calibrates some of
the product settings. When the calibration is complete,
the product starts to mow.

3.10 Product settings

You can use the keypad and the display on the product
or the Automower
the functions of the product. The functions of the product
have factory settings that are applicable for almost all
work areas, but the settings can be adapted to the
conditions for each work area.
3.11 Automower
The product can connect to mobile devices that have the
®
Automower Connect app installed. Automower
Connect is a free app for your mobile device. You can
use the extended functions for the product in the
Automower ® Connect app.
Dashboard shows the current status of the
• The
product. You can select an operating mode for the
product in the dashboard.
Map shows the current position of the product
• The
and the set centerpoint for the GeoFence function.
• In the Settings menu you can set the settings for
the product.
To
Statistics menu you can see the statistics of
• In the
the product.
• In the Messages menu you can find the previous
Fault messages and the Information messages of
the product.
®
The Automower
connectivity and Short-range Bluetooth
®
Connect app to do the settings for
®
Connect app
Connect app has Long-range cellular
® connectivity.
Installation - 23
®