Operation; Main Switch; To Start The Product; Operating Modes - Start - Husqvarna AUTOMOWER 420 Operator's Manual

4.1 Main switch

WARNING:
instructions carefully before you start the
product.
WARNING:
away from the rotating blades. Do not put
your hands or feet near to or below the
product when the cutting motor is on.
WARNING:
when persons, especially children, or
animals are in the work area.
• Set the Main switch in the
product.
• Set the Main switch in the
product is not in use or before you do inspection or
maintenance on the product.

4.2 To start the product

1. Push the STOP button to open the hatch on the
product.
2. Set the Main switch to position
3. Enter the PIN code.
4. Push the START button.
5. Select an operating mode. Refer to
modes - Start on page 34 .

34 - Operation

4 Operation
Read the safety
Keep your hands and feet
Do not use the product
1 position to start the
0 position when the
1 .
Operating
6. Push the OK button.
7. Close the hatch on the product.
Note:
If the product is parked in the charging station,
the product will start to operate when the battery is fully
charged and if the Schedule settings is set for operation.
Note:
The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.

4.3 Operating modes - Start

Main area
•
Secondary area
•
• Override schedule
Spot cutting
•
4.3.1 Main area
Use the operating mode Main area for the product to cut
and charge automatically.
4.3.2 Secondary area
Use Secondary area operating mode to cut secondary
areas. You must move the product manually between
the main area and the secondary area. The product cuts
for a selected period of time or until the battery is empty.
Note:
You must put the product manually in the
charging station to charge the product when it is in a
secondary area. The product will move out from the
charging station and stop when the battery is charged.
You must select an operating mode to start the product.
Note:
If you will cut the main area after the battery is
Main area mode before you
charged, set the product to
put the product in the charging station.
4.3.3 Override schedule
Override schedule to
Use the operating mode
temporarily override the Schedule settings for 24h or 3
days .
Note:
It is not possible to cut more than the maximum
cutting time for each day. Refer to
suitable operating hours on page 24 .
To calculate the
1201 - 005 - 19.03.2021