Husqvarna AUTOMOWER 310 Operator's Manual page 26

Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
GPS Assisted Navigation
Only for Automower ® 315X.
The GPS Assisted Navigation function helps the product
to select the most optimal operation. Use the Lawn
coverage function to do manual settings.
To set the GPS Assisted Navigation
Disable the GPS Assisted Navigation to make manual
Lawn coverage .
settings in
Note:
It is recommended to use GPS Assisted
Navigation.
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 23 .
2. Use the arrow buttons and the OK button to move
through the menu structure
coverage .
3. Push the OK button to enble or disable the
function.
4. Push the BACK button.
To set the Lawn Coverage function
To get access to the menu in the
1. Do steps 1–3 in
display of the product on page 23 .
2. Use the arrow buttons and the OK button to move
through the menu structure
Coverage > Area 1-3 .
3. Use the arrow button to select the area.
4. Push the OK button.
5. Measure the distance from the charging station to
the start of the area. Measure along the guide wire.
To measure the distance from the
Refer to
charging station on page 26 .
6. Push the number buttons to select the distance.
26 - Installation
7.
8.
C
9.
B
To do a test of the Lawn Coverage function
1.
2.
3.
4.
5.
6.
7.
To measure the distance from the charging station
1.
2.
3.
Installation > Lawn
4.
5.
6.
7.
8.
Installation > Lawn
To disable or enable the Lawn Coverage function
Disable or enable the
area.
1.
2.
Push the OK button.
Use the number buttons to select the percentage
of the cutting time the product must cut the area.
The percentage is equal to the area in relation to
the complete work area.
a) Measure the area.
b) Divide the measured area with the total work
area.
c) Convert the result to percentage.
Note:
The sum of Area 1-3 must be 100% or
less. If the sum is less than 100%, the product
sometimes starts to mow at the charging station.
To set the exit angle on page 28 .
Refer to
Push the BACK button.
Put the product in the charging station.
To get access to the menu in the
Do step 1-3 in
display of the product on page 23 .
Use the arrow buttons and the OK button to move
Installation > Lawn
through the menu structure
Coverage > Area 1-3 > More > Test .
Push the OK button.
Push the START button.
Close the hatch.
Make sure the product can find the area.
Put the product in the charging station.
Do steps 1–3 in To get access to the menu in the
display of the product on page 23 .
Use the arrow buttons and the OK button to move
Installation > Lawn
through the menu structure
Coverage > Area 1-3 > How far?
Use the number buttons to set 500 m / 500 yd as a
distance.
Push the OK button.
Use the arrow buttons and the OK button to move
Settings > Lawn
through the menu structure
Coverage > Area 1-3 > More > Test .
Push the OK button.
Push the STOP button when the product is at the
distance you select to measure. The distance
shows in the display.
Lawn Coverage function for each
To get access to the menu in the
Do steps 1–3 in
display of the product on page 23 .
Use the arrow buttons and the OK button to move
Installation > Lawn
through the menu structure
Coverage > Area 1-3 > Disable .
1440 - 004 - 24.03.2021