Husqvarna AUTOMOWER 310 Operator's Manual page 39

Message Cause
Battery problem
Temporary battery or firmware related issue
in the product.
Incorrect type of battery.
Battery temperature
The temperature in the battery is too high or
outside limits too low to start operation.
Wrong PIN code Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for a period of time.
No drive
The product has got caught in something and
has been slipping.
The work area includes a steep slope.
The guide wire is not laid diagonally in the
slope.
Collision sensor
The product body can not move freely
problem, front/rear around its chassis.
Alarm! Mower switch-
The alarm is activated because the product
ed off
had been switched off.
Alarm! Mower stop-
The alarm is activated because the product
ped
has been stopped.
Alarm! Mower lifted
The alarm is activated because the product
has been lifted.
Alarm! Mower tilted
The alarm is activated because the product
has been tilted.
Charging station
The contact between the charging plates on
blocked the product on the and contact plates on the
charging station may be poor and the prod-
uct has made a number of attempts to
charge.
An object is in the way of the product that
prevents it to enter the charging station.
The charging station is tilted or bent.
The guide wire is not installed correctly.
Stuck in charging sta-
There is an object in the way of the product
tion
preventing it from leaving the charging sta-
tion.
Charging system
Incorrect type of battery.
problem
1440 - 004 - 24.03.2021
Action
Restart the product. If the problem stays
speak to your authorized service technician.
Use original batteries recommended by the
manufacturer.
No action. The product will start to operate
when the temperature is in limits.
Enter the correct PIN code. Contact Husq-
varna customer service if you forget the PIN
code.
Free the product and rectify the reason for
the lack of drive. If it is due to wet grass, wait
until the lawn has dried before using the
product.
Steep slopes should be isolated. Refer to
put the boundary wire in a slope on page 16 .
Make sure that the guide wire is installed di-
agonally across the slope. Refer to
a secondary area on page 18 .
Check that the product body can move freely
around its chassis. If the problem stays
speak to your authorized service technician.
Adjust the security level in the
To set the security level on
menu. Refer to
page 24 .
Put the product in the charging station and
check that the charging plates and contact
plates make good contact.
Remove the object.
Put the baseplate on level ground.
Check if the guide wire is installed according
To install the
to the instructions. Refer to
guide wire on page 20 .
Remove the object.
Use original batteries recommended by the
manufacturer.
Troubleshooting - 39
To
To make
Security