Table of Contents
Advertisement
*2
Regarding the method of measuring SAR when using mobile phones in positions
other than against the ear, the international standard IEC62209-2 was set in
March 2010. On the other hand, Japanese technical regulation is currently
under deliberation by the Committee for Radio Wave Utilization Environment set
up in the Information and Communication Technology Group of the Advisory
Committee on Information and Communications. (As of October 2011)
FCC notice
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
The device complies with 15.205 of the FCC Rules.
Note:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help and for additional suggestions.
Warning
64
The user is cautioned that changes or modifications not
expressly approved by the manufacturer could void the userﾕs
authority to operate the equipment.
FCC RF exposure information
This model phone is a radio transmitter and receiver.
It is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the
Federal Communications Commission of the U.S. Government.
The guidelines are based on standards that were developed by
independent scientific organizations through periodic and
thorough evaluation of scientific studies. The standards include
a substantial safety margin designed to assure the safety of all
persons, regardless of age and health.
The exposure standard for wireless handsets employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg. The tests are
performed in positions and locations (e.g., at the ear and worn on
the body) as required by the FCC for each model.
The SAR value for this model handset when tested for use at the
ear is 0.347 W/kg and when worn on the body, as described in
this user guide, is 0.59 W/kg.
Body-worn operation
This phone was tested for typical body-worn operations with the
back of the phone kept at a distance of 1 cm from the body. To
maintain compliance with FCC RF exposure requirements, use
accessories that maintain a 1 cm separation distance between
your body and the back of the phone. The use of belt clips,
holsters and similar accessories should not contain metallic
components.
The use of accessories that do not satisfy these requirements
may not comply with FCC RF exposure requirements, and should
be avoided.
Advertisement
Table of Contents
