HP Jet Fusion 4200 Product Documentation Site Preparation Manual page 53

General access & equipment unloading
Is the site entrance ready to receive the delivery? Deliveries are commonly made
by truck.
Is there an easily accessible unloading area, with sufficient space to unload and
maneuver the equipment?
Has the route to the installation area been checked to meet all requirements
(height, width, and clearance of ceilings, doorways, ramps, and corridors) and is the
conveyance route clear?
Have specialist movers been contracted to unload and move the equipment on the
date required?
Are the specialist movers aware of the specifications provided in this document?
Is there a pallet jack available? It is needed to transport the equipment, and may be
needed to unload it from the truck.
Will you install the printer/processing station on a second level or higher? If so, is
there a suitable crane contracted for installation? Are the appropriate crane
attachments available?
Will the operator be available for the full amount of time required for the
installation training (2 days)?
Room layout and flooring
Is there sufficient space around the equipment?
Has all room construction and painting been completed?
Does the floor load-bearing capacity meet the specifications in the site preparation
guide?
Does the floor surface meet the specifications in the site preparation guide? If
special reinforcements are necessary, are they completed?
Is the floor surface free from static electricity? See Safety Data Sheets at
http://www.hp.com/go/msds/.
Safety requirements
Is there an emergency exit in the print production area, with easy access and free
from any obstruction?
Have the two fire extinguishers been fitted in the print production and storage
areas? Is the print production fire extinguisher rated for electrical fire?
Does the area meet the Restricted Access Location requirements in the zone
surrounding the system?
Do the users who operate the system have appropriate technical training and
experience necessary to be aware of the hazards to which they may be exposed in
performing a task and to take appropriate measures to minimize the risks?
Does the room meet the minimal ventilation (ACHs) standard required by local
regulations and/or HP?
ENWW
Yes No
Yes No
Yes No
Comments
Comments
(Required)
(Required)
Comments
(Required)
(Required)
(Required)
49