Table of Contents
Advertisement
3.8
Event service specifications
The following table shows the supported notifications for each object.
The Event notification is used to notify the Alarm and Event. The COV notification is used to notify the change of Present
Value.
Selection of "Confirmed" or "Unconfirmed" can be made for each notification target.
Control item
On Off Setup
On Off State
Alarm Signal
Error Code
Operational Mode Setup
Operational Mode State
Fan Speed Setup
Fan Speed State
Room Temp
[Water Temp]
Set Temp
[Set Water Temp]
Filter Sign
[Circulating Water Exchange Sign]
Filter Sign Reset
[Circulating Water Exchange Sign Reset]
Prohibition On Off
Prohibition Mode
Prohibition Filter Sign Reset
[Prohibition Circulating Water Exchange Sign Reset]
Prohibition Set Temperature
M-NET Communication State
System Forced Off
Air Direction Setup
Air Direction State
Set Temp Cool
Set Temp Heat
Set Temp Auto
Set High Limit Setback Temp
Set Low Limit Setback Temp
Ventilation Mode Setup
Ventilation Mode State
Air To Water Mode Setup
Air To Water Mode State
Expansion Controller Communication State
Notification Class
Device
: Notification is settable using setting data
: Notification is not settable
*1: Inside the brackets indicates control item for BU or AU group. (Refer to section 1.2 Restrictions/Cautions.)
Event
Object ID
notification
BO_xxxx01
BI_xxxx02
BI_xxxx03
MI_xxxx04
MO_xxxx05
MI_xxxx06
MO_xxxx07
MI_xxxx08
AI_xxxx09
AV_xxxx10
BI_xxxx11
BV_xxxx12
BV_xxxx13
BV_xxxx14
BV_xxxx15
BV_xxxx16
BI_xxxx20
BV_xxxx21
BV_999921
MO_xxxx22
MI_xxxx23
AV_xxxx24
AV_xxxx25
AV_xxxx26
AV_xxxx27
AV_xxxx28
MO_xxxx35
MI_xxxx36
MO_xxxx37
MI_xxxx38
BI_xx9981
CLS_xxxxxx
DEV_xxxxxx
- 19 -
COV
notification
Notes
*1
*1
*1
*1
*1
Advertisement
Table of Contents
