Table of Contents
Advertisement
Installation and operating manual
5. Commissioning
After the METPOINT
UD01 plug-on display has been correctly installed and connected, it is ready for operation.
®
6. Decommissioning
To decommissioning the plug-on display, disconnect it from the power supply, remove it from the transducer by
performing the installation steps in reverse order and dispose of it according to the disposal instructions in chapter
"9. Dismantling and disposal", page 18.
7. Maintenance and servicing
The plug-on display does not need any maintenance. From time to time, it might need to be cleaned as described
below.
7.1. Cleaning
To clean the METPOINT
mild conventional detergent.
Spray a little detergent onto the clean cotton cloth or tissue and carefully wipe the component. Dry it with a clean
cloth. Observe all hygiene instructions application on site.
NOTE
Damage caused by improper cleaning
Cleaning with a wet cloth, pointed implement or aggressive detergent can cause damage to
the plug-on display and its electronic components.
•
•
•
8. Troubleshooting and repair
In the event of a malfunction of the device, return it to the manufacturer for repair. Clean the device carefully and
pack it so that it is protected against impact. Return the device to the manufacturer, enclosing a return declaration
with a detailed description of the error/malfunction. If your device has come into contact with a hazardous
substance, also enclose a declaration of decontamination. The relevant templates can be downloaded from our
homepage at www.beko-technologies.de. If your device arrives at our service workshop without a declaration of
decontamination, and should our personnel be concerned about any media with which it might have come into
contact, we will contact you. A repair will only be performed after we have received the relevant declaration of
decontamination. If the device has been exposed to a hazardous substance, take all necessary safety precautions
when cleaning it!
9. Dismantling and disposal
Dispose of the device according to the European Directives 2002/96/EC and 2003/108/EC (waste electrical and
electronic equipment (WEEE)). Never dispose of it with normal household waste!
If the device has been in contact with a hazardous substance, it might need to be disposed of through a specialist
hazardous waste disposal contractor!
18
UD01 plug-on display, use a damp (but not wet) cotton cloth or disposable tissue and a
®
Never clean the device with a wet cloth.
Do not use aggressive detergents.
Do not clean the display with a pointed or sharp-edged implement
EN
METPOINT
UD01
®
Advertisement
Table of Contents
