System Shell - LG niagara4 MultiSITE Edge 10 User Manual

The DEBUG port is a standard Micro-A type USB port for serial debug communications to the device. NOTE: Login requires
administrator level platform credentials.
The RESET button does an immediate shutdown of the device. It is the equivalent of removing power.
Step 1 Ensure that the device's power is off.
Step 2 Press and hold down the Factory Reset button as you power up the device. You will see one of the
following:
a. Status LED blinks at a fast rate (5Hz)
b. If you have the serial shell you will see a prompt to release the button:
"Restore button press detected. Please release button to
initiate factory restore.
Restore mode is set!
Step 3 Release the button to proceed with the factory restore process.
Note:
The FACTORY RESET button must be released within 5 seconds of the fast blink.
Step 4 When the MS-E10 device powers up, login with default credentials to proceed.
Factory restore involves several reboots. During reboot, the BEAT LED blinks at a rapid rate. When the BEAT LED
blinks at normal rate, login with default credentials.
Note:
Do not remove power from the device while the BEAT LED blinks at a rapid rate since this causes physical
stress on the equipment and prevents good connections between the device and I/O modules.

System shell

Any QNX-based MS-E10 device has a "system shell," providing low-level access to a few basic platform settings. Using a special
power-up mode and a serial connection via a USB-to-MicroUSB cable connected to the MS-E10 device's Debug port, you can
access this system shell. Note that system shell is also available via SSH (providing that SSH is enabled in the MS-E10 device).
Typical usage is for troubleshooting. However, in the case of IP address misconfiguration, you can use the serial system shell in
order to regain access to the unit.
Note:
Also, depending on your preference, you may wish to use the serial shell to set the MS-E10 device's IP address.
The following sections provide more details.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
MS- E10 User Guide
64