Brother TN 2010 Instructions

Download this manual

INSTRUCTIONS FOR REFILLING BROTHER TN 2010 CARTRIDGE

BROTHER DCP-7055, DCP 7055W, DCP-7057, HL-2130. HL -2132, HL-2135W

When to refill:

The Brother machine lets you know when you are low on toner using a series of LED lights on the printer.

You can force the printer to continue to print and use up as much toner as possible by selecting

CONTINUE MODE.

How to select Continue

HL 2130 /2132/2135W machines :

To force the machine to continue printing after the LEDs indicate REPLACE TONER, press Go seven times to

enter "Continue mode" (all the LEDs flash twice, and then the Ready LED turns on).

The machine will then continue printing until the LEDs indicate TONER ENDED

DCP 7055 / DCP 7055W machines – there is no GO Button. So follow instructions below

Press Menu, press arrow keys to choose 1.General Setup and press OK,

Press arrow keys to choose 4.Replace Toner, and press OK,

Press arrow keys to choose Continue and press OK.

The machine will then continue printing until the LEDs indicate TONER ENDED

(To return to the default setting (Stop mode), press Go seven times (all the LEDs flash once).

TONER LOW - The Toner LED will turn on for 2 seconds and off for 3 seconds -

ignore message - Keep printing

In "Stop mode" you would be required to empty and refill at this point.

However you can use the CONTINUE MODE to override this default setting and

print for longer see below.

mode:

Replace toner (CONTINUE MODE) – the toner light is on but you can continue to

print.

CONTINUE MODE - Toner Light on continuously with error light lit - machine will

not print – Empty it and Refill it (TONER ENDED)

You must now empty and refill.

Toner that doesn't cost the earth

Printed on recycled paper, using refilled cartridges

Page 1 When to refill: The Brother machine lets you know when you are low on toner using a series of LED lights on the printer. You can force the printer to continue to print and use up as much toner as possible by selecting CONTINUE MODE.
Page 2 You must do this every refill. garage. Brother cartridges can leave as much as 25 grams of Toner can be very waste toner in the cartridge, while reporting toner messy - empty the empty/refusing to print.
Page 3 Printed on recycled paper, using refilled cartridges INSTRUCTIONS FOR RESETTING BROTHER TN 2010 Brother has introduced a small flag gear in its cartridges that resets the printer. You will need to reset the flag gear in order to reset the cartridge. Follow instructions below.
Page 4 Toner that doesn’t cost the earth Printed on recycled paper, using refilled cartridges Remove only the white reset gear. Set the reset gear spring as shown. Note the red arrows show the exact position that the spring fits. Replace the gears as shown opposite. Note that the gear teeth are not meshed when set, which is how it should be.
Page 5 Toner that doesn’t cost the earth Printed on recycled paper, using refilled cartridges Correct Position Make sure the black arrow on the cover is aligned with the white arrow marked #3 on the TN2010 gear. Safety information: Toner powder should be treated as a nuisance dust. Not to be used by children. Avoid inhalation.