Advertisement
[ In the case of PDFY-10, 16, 24, 32, 40, 48NMU-A and PDFY-P06, P08, P12, P15, P18, P24, P27, P30, P36, P48NMU-E ]
1. Pass the white connector (3P:small) of the drain pump
assembly through rubber bushing (A) and the white
connector (3P:Large) through rubber bushing (B).
2. Remove the screws, and then remove the control box cover.
Control box cover
Indoor
Screw
3. Run the drain pump and drain sensor wires through the holes shown below.
Screw
Drain sensor
connector
5
White Connector (small)
White Connector
(Large)
Rubber bushing
(B)
Rubber bushing
(A)
Drain pump
connector
Advertisement
