Software Installation; Operating System; Software; Operation - Bosch 1 687 023 850 Original Instructions Manual

en | 16 | 1 687 023 850 – 858 | Operation
Fig. 8: Installation position of tower in tester
4.3

Software installation

4.3.1

Operating system

i
The WIN 10 operating system is factory-installed.
An active internet connection is required for the
duration of a one-time Windows license activation.
If the Windows license is not activated, some
Windows functions will be unavailable or
restricted.
1. Supply the product with power.
2. Switch on the multi-point connector.
3. Switch on the On/Off switch on the back of the PC.
4. Switch on the PC by way of the Standby button.
 The operating system starts up.
 The language settings are displayed.
5. Select the local language.
i
Optionally, after the national language has
been selected, additional settings such as apps
language, keyboard layout or time zone can be set.
6. Read and follow the instructions on the screen.
 The PC is ready for operation.
4.3.2

Software

The software (e.g. BEA-PC, FSA, ESI[tronic], EPS) is
supplied with the product. If the software is not pre-
installed, it must be installed using the data carrier
provided with the product.
|
1 689 989 347 2021-04-24
5.

Operation

5.1

Switching on/off

5.1.1

switching on

i
Always allow a waiting time of up to three minutes
in the following situations:
$
Between switching the PC off and on at the
multiple socket outlet (not recommended).
$
Between switch-off and switch-on using the ON/
OFF switch at the PC power supply unit (back
of PC).
i
The wait time is shortened if the power key on the
front is used for switching on and off.
1. Supply the product with power.
Switch on the multiple socket outlet on the trolley
or connect the PC directly to the power supply.
2. Switch on the PC via the on/off switch on the back
of the PC.
 The operating system starts up.
i
The computer can then be switched off and on via
the power key on the front of the PC.
5.1.2

Switching off

1. End all programs.
2. Select "Start >> Shutdown".
 The operating system shuts down.
 The PC switches off automatically.
i
Alternatively, the computer can be switched off and
on via the power key on the front of the PC.
5.2

Instructions in case of faults

i
Contact Customer Service if any problem cannot be
rectified employing the remedies listed below.
5.2.1

Display

Fault
No display. The monitor
remains blank.
No display. The monitor
remains blank although the
PC is switched on.
Remedy
Make sure the PC and all other
components are being supplied
with power.
Make sure the multiple socket
outlet at the trolley has been
switched on.
Make sure all connecting
cables and the power cord are
connected to the monitor.
Check the monitor settings
(brightness, contrast, alignment
etc.).
Robert Bosch GmbH