Siemens SINAMICS G130 Operating Instructions Manual page 19

Connection
The AOP30 is connected as follows:
1. Connect the power supply cable to the interface for the electronic power supply (X524).
2. Connect the standard cable to the serial RS232 interface (X540) of the Control Unit.
Figure 4-2
CAUTION
The connection cable to AOP30 may only contain the three contacts which are shown in
the drawing; a completely allocated cable may not be used.
The AOP30 operator panel
Operating Instructions, 03/2012, A5E00331451A
Signal cable between the Control Unit and AOP30
Connection
17