Jog; Increase Setpoint / Decrease Setpoint - Siemens SINAMICS G130 Operating Instructions Manual

5.7.4

Jog

Settings: MENU – Commissioning/Service – AOP settings – Control settings
JOG key active (factory setting: No)
● Yes: The jog key is effective in the LOCAL mode in the state "ready to power-up" (not in
● No: The JOG key has no effect in the LOCAL mode
5.7.5

Increase setpoint / decrease setpoint

You can use the increase and decrease keys to set the setpoint with a resolution of 1min
the maximum speed.
You can also enter the setpoint numerically. To do so, press F2 in the operation screen. The
system displays an field for entering the required speed. Enter the required value using the
numeric keypad. Press F5 "OK" to confirm the setpoint.
When you enter values numerically, you can enter any speed between the minimum speed
(p1080) and the maximum speed (p1082).
Setpoint entry in LOCAL mode is unipolar. You can change the direction of rotation by
pressing the key that allows you to switch between CW/CCW rotation.
● CW rotation and "Increase key" mean:
● CCW rotation and "Increase key" mean:
The AOP30 operator panel
Operating Instructions, 03/2012, A5E00331451A
"operation"). The speed that is set in parameter p1058 is approached.
The displayed setpoint is positive and the output frequency is increased.
The displayed setpoint is negative and the output frequency is increased.
Control via the operator panel
5.7 Operation via the operator panel (LOCAL mode)
of
-1
37