Bosch Pack201HS Instruction Manual page 106

Pack201 | Maintenance | Section 6
Infeed Section
Assembly
Chain
Pushers and pins
Drive Sprockets and drive
mechanisms.
Gear box
Product Guides
Bearings
Proximity switch
WARNING
When the chain or chains are
adjusted, avoid excessive tension.
If they are too tight, it will cause
premature wear on the sprockets
and chain.
Backstand Section
Assembly
Rollers
Main Spindles
Bearings
Power feed roll
Gear box
Splicer
Dancer arm
Monitoring devices
Pressure Roller
Former Section
Assembly
Former
Wings, mount block, and
associated components.
© Bosch Packaging Technology, Inc.
All rights reserved 2012
Maintenance Check
Remove and clean using a soap solution. Lightly lubricate
chains and chain guides.
Check flight length/package length ratio.
Inspect for wear and proper tension.
Inspect for wear and condition.
Inspect for wear
Inspect for leaks
Inspect and adjust for optimum product flow. Replace broken
knobs.
Inspect for wear. Replace if necessary.
Inspect for function and proper setup.
Maintenance Check
Clean all rollers and related components. Check for wear and
free rotation.
Inspect for wear and condition.
Inspect for wear and condition. Lubricate.
Inspect for wear, proper setup and operaton.
Inspect for leaks.
Inspect for wear and proper setup.
Inspect for proper operation.
Check for proper setup and operation.
Check operation. Adjust by turning the shaft if necessary.
Maintenance Check
Inspect for proper sizing to product. Check for proper
mounting and wear. Check for proper height, centerline, and
angle position.
Clean as needed. Check for sharp edges and smooth if
necessary.
EN | 9