Advertisement
Quick Links
Horn Kit
Workman
Model No. 133-3016
Model No. 133-3017
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Note:
Determine the left and right sides of the machine from the normal operating position.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
GTX Utility Vehicle
Description
No parts required
12 V horn assembly (for Gasoline GTX
vehicles)
48 V horn assembly (for Electric GTX
vehicles)
Hex-head screw (5/16 x 3/4 inch)
Flange nut (5/16 inch)
Horn switch
Rubber button
Fuse (30 A)
No parts required
No parts required
Register at www.Toro.com.
Form No. 3435-975 Rev A
Installation Instructions
Qty.
–
Prepare the machine.
1
1
Install the horn.
1
1
1
Install the horn switch.
1
1
Install the fuse into the fuse block.
–
Connect the battery.
–
Test the horn function.
Original Instructions (EN)
All Rights Reserved *3435-975* A
Printed in the USA
Use
Advertisement
Related Manuals for Toro Workman 133-3016
Summary of Contents for Toro Workman 133-3016
- Page 1 No parts required Test the horn function. Note: Determine the left and right sides of the machine from the normal operating position. © 2019—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3435-975* A 8111 Lyndale Avenue South...
-
Page 2: Preparing The Machine
Preparing the Machine No Parts Required For Gasoline GTX Vehicles Park the machine on a level surface, set the parking brake, shut off the engine, and remove g034598 the key. Figure 1 Disconnect the negative-battery cable; refer to 1. Dash bracket 3. - Page 3 For Electric GTX Vehicles Release the rubber straps on both sides of the hood and raise the hood. Install the 48 V horn assembly to the existing Installing and Connecting hole in the dash bracket with the hex-head screw (5/16 x 3/4 inch) and flange nut (5/16 the Horn Switch inch) as shown in Figure...
-
Page 4: Installing The Fuse
Plug the female connector from the main wire harness to the male connector on the horn switch (Figure Installing the Fuse Parts needed for this procedure: Fuse (30 A) For Gasoline GTX Vehicles For machines with serial number 403999999 and before: g034702 Figure 7... - Page 5 For Electric GTX Vehicles For machines with serial number 403999999 and before: Install the fuse (30 A) into the opening in the fuse block (Figure 10). g034704 Figure 10 1. Fuse (30 A) 2. Fuse block For machines with serial number 404000000 and after: Install the fuse (30 A) into the opening in the fuse block...
-
Page 6: Connecting The Battery
Connecting the Battery No Parts Required For Gasoline GTX Vehicles Connect the negative-battery cable; refer to your Operator’s Manual. For Electric GTX Vehicles Connect the main negative-battery cable (black) that connects the bank of batteries to the ground point of the machine;... - Page 7 Notes:...