GE FVP110 Maintenance Manual page 210

GE Energy
Relative Index Parameter
Index
67 2067 AUTO_TUNE
_RESULT
68 2068 AUTO_TUNE
_STATE
69 2069 SERVO_RET
_TO
_DFLT
70 2070 ADVAL_FW
71 2071 ADVAL_BW
72 2072 ADVAL_
PRESS
73 2073 ADVAL_T
74 2074 TOTAL_
CYCLE
_COUNT
75 2075 CYCLE
_DEADBAND
76 2076 CYCLE_
COUNT
_LIM
77 2077 TOTAL_
TRAVEL
78 2078 TRAVEL
_DEADBAND
79 2079 TRAVEL_
LIM
80 2080 TOTAL_
OPEN
_TIME
Table 61 Transducer Block Parameters (Continued)
Default
Name (factory
setting)
1
0
1
–
–
–
–
0
0.25%
2^32-1
0
0.25%
2^32-1
0 hour
FVP 110 Fieldbus Valve Positioner Manual
Write
— Indicates the result of auto tuning.
— Indicates auto tuning sequence number.
O/S Writing 2 to this parameter resets all control
parameters to the defaults:
1 = off
2 = set (to the defaults)
— Digital value of valve control signal, setpoint
equivalent to A/D value of valve position signal.
— A/D value of valve position signal
— A/D value of pressure from sensor
— A/D value of temperature from sensor
O/S Total number of cycles. To reset the count,
write 0.
— Dead band of cycle counting
High-limit alarm setting for
TOTAL_CYCLE_COUNT.
When TOTAL_CYCLE_COUNT has reached
this setting, a block alarm is generated.
O/S Total amount of travel. To reset the count, write
0.
Dead band of travel integration
High-limit alarm setting for TOTAL_TRAVEL.
When TOTAL_TRAVEL has reached this
setting, a block alarm is generated.
Total time other than counted for
TOTAL_CLOSE_TIME. To reset the count,
write 0.
194
Description