GE FVP110 Maintenance Manual page 218

GE Energy
Relative Index
Index
DI1 DI2
8 6008 6108
9 6009 6109
10 6010 6110
11 60011 6111
12 6012 6112
13 6013 6113
14 6014 6114
15 6015 6115
16 6016 6116
17 6017 6117
18 6018 6118
19 6019 6119
20 6020 6120
Table 63 DI Block Parameters (Continued)
Parameter Default
Name (factory
setting)
OUT_D —
SIMULATE_D disable
XD_STATE 0
OUT_STATE 0
GRANT_ 0
DENY
IO_OPTS 0
STATUS_ 0
OPTS
CHANNEL 2 or 3
PV_FTIME –
FIELD_VAL_ –
D
UPDATE_EV –
T
BLOCK_ALM –
ALARM_SUM enable
FVP 110 Fieldbus Valve Positioner Manual
Write
Man Indicates the output value and its status.
— Used to determine whether to use the limit
switch signal input from the transducer block or
use the user-set value. When this parameter is
set to disable, the block uses the actual input
value and status.
Index to the text describing the states of the
discrete value obtained from the transducer,
but not supported by FVP110
Index to the text describing the states of a
discrete output, but not supported by FVP110.
Used to check whether various user operations
can be put into effective. Before operations, in
the GRANT parameter component, set the bits
(to 1) corresponding to the intended
operations. After the operations, check the
DENY parameter component. If the
corresponding bits are not set (to 1) in DENY, it
proves that the corresponding operation has
been put into effective.
O/S Settings for the I/O processing of the block.
O/S Defines block actions depending on block
status conditions.
O/S Defines the channel number of the hardware
channel connected to the transducer block.
Always set 2 for the DI1 block and 3 for DI2 in a
FVP110.
— Time constant of filter for PV_D.
Status of limit switch signal obtained from the
transducer block
– Shows the contents of an update event upon
occurrence.
– Shows the contents of a block alarm upon
occurrence.
Shows the alarm summary (current alarm
statuses, acknowledged/unacknowledged
states, masking states) for the DI block.
202
Description