Sealey VS7233 Instructions

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions and properly
maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND
CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY
CAUSE DAMAGE OR PERSONAL INJURY, AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
û Do not use the stud extractor set for any purpose other than for which it is designed.
ü Keep the kit free from dirt and grime.
ü Ensure your work area is tidy and free from hazards.
ü Ensure the correct sizes of guide and drill are used to avoid injury and damage to the set.
r
WARNING: The warnings, cautions and instructions discussed in this instruction manual cannot cover
all possible conditions and situations that may occur. It must be understood that common sense and
caution are factors which can not be built into this product, but must be applied by the operator.
2. INTRODUCTION
Suitable for the removal of broken studs and bolts. Supplied with centring pilots for Ø4.75-9.75mm studs, drills,
extractor shafts and nuts. Ideal for engine manifold studs.
3. CONTENTS
4. SIZE GUIDE CHART
Stud size 4.0
Guide size B1
Guide ext. Ø 6.0
Drill to use 3.2
Pin to use PIN 1
Hex extractor D1
4.75 4.75 4.75
B2 B3 B4
8.0 9.0 10.0
3.2 3.2 3.2
PIN 1 PIN 1 PIN 1
D1 D1 D1
Original Language Version
INSTRUCTIONS FOR:
STUD EXTRACTOR SET
MODEL No:
6.1 7.2 7.2
B5 B6 B7
10.0 11.0 12.0
4.8 4.8 4.8
PIN 2 PIN 2 PIN 2
D2 D2 D2
VS7233
7.2 9.0 9.75
B8 B9 B10
13.0 13.0 14.0
4.8 6.4 6.4
PIN 2 PIN 3 PIN 3
D2 D3 D3
VS7233 Issue No: 2 (l) - 06/08/15
12 15
- -
- -
8.0 8.9
PIN 4 PIN 5
D4 D4