Sealey AUTO SERVICE VS720 Manual

Thank you for purchasing a Sealey Product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT:
REQUIREMENTS, WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY
AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.2 GENERAL SAFETY
 WARNING! Ensure Health & Safety, local authority, and general
workshop practice regulations are adhered to when using this
tool.
 WARNING! Familiarise yourself with the specific applications
and limitations of the bush replacement tool, as well as any
potential hazards.
 This tool should be used in conjunction with inspection
maintenance
procedures recommended in the vehicle manufacturer's manual.
 Ensure that the bush replacement tool is the correct tool for the
task.
DO NOT use the bush replacement tool for any purpose other
than that for which it is designed.
 Ensure that the vehicle is properly supported with axle stands
before working under the vehicle.
 Ensure there is adequate lighting prior to using the bush
replacement tool. A range of inspection lamps is available from
your local Sealey dealer.
 Keep children and unauthorised persons away from the working
area.
 DO NOT use the bush replacement tool if any parts are damaged
or missing, as this may cause failure and/or personal injury.
 DO NOT use the bush replacement tool when you are tired, or
under the influence of alcohol, drugs or intoxicating medication.
2. OPERATING INSTRUCTIONS
Fig.2
2.1. REMOVING A BUSH.
Refer to Fig.2:
2.1.1. Screw the threaded bar F into the bush removal cup A and insert the threaded bar into the bush to be removed
from the vehicle rear trailing arm bush-mounting (Step one).
2.1.2. Locate components B, C, D and E on threaded bar F (Step two).
2.1.3. Using a ring spanner, or ratchet wrench, tighten nut E (Step three) until the bush is clear of the vehicle rear trailing
arm and located in component B (Step four).
2.1.4. Remove the bush from component B by unscrewing the bush removal cup A and components C, D and E from
the threaded bar F (Step 5).
2.1.5. Replace all the components comprising the bush replacement tool in the appropriate slots in the carrying case
(Fig.4).
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
Original Language Version
INSTRUCTIONS FOR:
BUSH REPLACEMENT TOOL FOR
VAUXHALL/OPEL VECTRA
MODEL No: VS720
ALWAYS KEEP FORCE (F) SCREW
WELL LUBRICATED.
DO NOT USE AIR TOOLS
Threaded rod maximum load 150Nm. Exceeding this load
will shorten the life of the threaded rod. The threaded
rod is considered to be a consumable item and is NOT
covered under warranty.
Fig.1

VS720 Issue No. 3 - 23/08/11