Pioneer PRA-BD11 Operating Instructions Manual page 12

Installation
6. Attach the cable clamp.
÷ Insert the cable clamp supplied with the unit into the specified aperture in the DVD
recorder and secure it.
Note:
The mounting location of the PRA-BD11 input board differs from that of the PRA-BD12
output board. Make sure that they are installed in the correct location.
PRA-BD12 output board
mounting location
7. Bend the two DVD recorder FFC cables.
÷ When installing the PRA-BD12 output board, bend both DVD recorder FFC cables
beyond the reinforced end section away from the output board at a 90° angle relative
to the reinforcement to ensure that they do not bulge and come into contact with the
output board. See figure below.
Note:
Make sure that the FFC cable is not disconnected from the DVD recorder and that the
cable is not exposed to excessive pressure when bent.
12
PRA-BD11 / PRA-BD12
En
FFC cables
PRA-BD11 input board
mounting location
Blue reinforced area