Pioneer PRA-BD11 Operating Instructions Manual page 21

Note:
When "SDI" is selected as input, under the following conditions, the error message [No
SDI_V Input / No SDI_A Input] will appear on the monitor if preview, record or other
operations are performed on the DVD recorder:
1. No signal input via the SDI input connector
2. A video signal other than the supported format (270 Mb/S, 525i/625i, 4:2:2
component) is input to the SDI input connectors
3. An audio signal other than the supported format (linear PCM, 48 kHz, 20-bit, channel
1/2) is input to the SDI input connectors
Check the format of the signal input to the SDI input connectors when the
above error messages appear.
The above error messages may also appear when a data signal is input in the vertical
blanking area of the video signal.
Selecting AES/EBU input
Display the DVD recorder's Function
Menu, and select "AES/EBU" from
[A Input] on the STATUS section.
The "SDI" menu and "AES/EBU"
menu are added to [A Input] and
becomes available for selection
when this unit is installed.
Note:
When "AES/EBU" is selected as input, be sure that only AES/EBU signals synchronized
to the video signal set with [V Input] are actually input. Inputting a non-synchronized
signal may result in unstable operation of the DVD recorder.
Note:
When "AES/EBU" is selected as input, under the following conditions, the error message
[No AES / EBU Input] will appear on the monitor if preview, record or other operations
are performed on the DVD recorder:
1. No signal input via the AES/EBU input connector
2. A signal other the support format (linear PCM, 48 kHz, 16/18/20-bit, industrial format)
is input to the AES/EBU input connectors.
When "No AES/EBU Input" appears, check the format of the signal input to
the AES/EBU input connectors.
Using PRA-BD11
STATUS section = [A Input]
21
PRA-BD11 / PRA-BD12
En