Before Using For The First Time; Operation - Silvercrest SDBK 2400 D3 Operating Instructions Manual

B&3(B'DPSIEJHOHLVHQB%ERRN 6HLWH  0LWWZRFK  -XOL   
6. Before using for the
first time
1. Ensure that you have pulled out the
mains plug.
2. The switch 11 is in the top position
. Remove the steam iron from the
stand 12. The cable base 10 remains
in the stand.
3. Peel the protective foil off the
sole plate 18.
4. Open the lid 2 (of the water tank).
5. Half-fill the water tank 16.
6. Place the steam iron in the stand 12.
7. Insert the mains plug into a wall socket
corresponding to the technical data.
8. Set the temperature controller 19 to
MAX.
The temperature control lamp 14 lights
up.
9. When the device has reached the de-
sired temperature (temperature control
lamp 14 goes out), iron an old cotton
towel in steam mode until the water tank
16 is empty.
50 GB

7. Operation

DANGER!
~ The sole plate 18 becomes very hot dur-
ing operation. Only touch the handle 6
and control elements of the steam iron
during operation.
~ Even during short interruptions, always
place the steam iron in the stand 12
and never on its sole plate 18. There is
a fire hazard!
NOTE:
• You may notice an odour when using
for the first time. This is a result of the
manufacturing process and is not a de-
fect with the device. Ensure adequate
ventilation.
The sole plate18 cools down slightly during
ironing. In order to reach the set temperature
again, the device heats the sole plate18 up
again, during which the temperature control
lamp 14 lights up. The temperature control
lamp 14 goes out again when the set tem-
perature is reached. This process repeats it-
self during ironing.
Ironing with cable: simply continue iron-
ing during the heating phase.
Cable-free ironing: the steam iron stands
on the stand 12.
Wait until the temperature control lamp 14
goes out.