Motorola OM 2000 Installation & Operation Manual page 3

CAUTION
These servicing and installation instructions are for use by qualified personnel only. To reduce the risk
of electrical shock, do not perform any servicing other than that contained in the Installation and
Troubleshooting Instructions unless you are qualified to do so. Refer all servicing to qualified service
personnel.
SPECIAL SYMBOLS THAT MIGHT APPEAR ON THE EQUIPMENT
This symbol indicates that dangerous voltage levels are present within the equipment.
These voltages are not insulated and may be of sufficient strength to cause serious
bodily injury when touched. The symbol may also appear on schematics.
The exclamation point, within an equilateral triangle, is intended to alert the user to
the presence of important installation, servicing, and operating instructions in the
documents accompanying the equipment.
For continued protection against fire, replace all fuses only with fuses having the
same electrical ratings marked at the location of the fuse.
Electrostatic discharge (ESD) can damage the OM unit and circuit card asOMblies.
Wear an antistatic wrist strap attached to a chassis ground to prevent ESD damage.
This equipment operates over the marked Voltage and Frequency range without
requiring manual setting of any selector switches. Different types of line cord sets
may be used for connections to the mains supply circuit and should comply with the
electrical code requirements of the country of use. This equipment requires a
grounding conductor in the line cord.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE. THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND NO
OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.
CAUTION: TO PREVENT ELECTRICAL SHOCK, IF THIS UNIT IS PROVIDED WITH A POLARIZED
PLUG, DO NOT CONNECT THE PLUG INTO AN EXTENSION CORD, RECEPTACLE, OR OTHER
OUTLET UNLESS THE PLUG CAN BE FULLY INSERTED WITH NO PART OF THE BLADES EXPOSED.
CAUTION: TO ENSURE REGULATORY AND SAFETY COMPLIANCE, USE ONLY THE PROVIDED
POWER CABLES.
EQUIPMENT MUST BE CONNECTED TO PROTECTIVE EARTH
THIS EQUIPMENT HAS BEEN DESIGNED FOR CONNECTION TO AN IT POWER DISTRIBUTION
SYSTEM WHEN POWERED BY AC.
THIS DEVICE WHEN POWERED BY DC MUST BE PROTECTED BY A LISTED BRANCH CIRCUIT
PROTECTOR RATED MAXIMUM 25A.
It is recommended that the customer install an AC surge arrestor in the AC outlet to which this device
is connected. This is to avoid damaging the equipment by local lightning strikes and other electrical
surges.
CAUTION: THE POWER SUPPLY PLUG IS INTENDED TO SERVE AS A POWER DISCONNECT
DEVICE. THE SOCKET-OUTLET SHALL BE INSTALLED NEAR THE EQUIPMENT AND SHALL BE
EASILY ACCESSIBLE.
i