CONTENTS 1 IMPORTANT SAFETY INSTRUCTIONS ........3 2 UNPACKING YOUR DRAWER MICROWAVE ........4 Important Notes to the Installer ......4 Important Notes to the Consumer .....4 3 INFORMATION YOU NEED TO KNOW ..........5 Clearances and Dimensions ......5 GROUNDING INSTRUCTIONS ......5 Drawer Microwave Measurements ....6 4 INSTALLATION INSTRUCTIONS..7 Anti-Tip Block .............7 Electrical Outlet..........7...
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT–Please Read and Follow • WARNING: If the information in this manual is not followed exactly, a fire or electrical shock • Before beginning, read these instructions thor- may result that could cause property damage, oughly and carefully. personal injury or death.
UNPACKING YOUR DRAWER MICROWAVE Important Notes to the • Remove all packing materials from inside the Drawer Microwave. DO NOT REMOVE THE Installer WAVEGUIDE COVER, which is located on the • Read all of the Installation Manual before in- top of the appliance. stalling the Drawer Microwave.
INFORMATION YOU NEED TO KNOW GROUNDING Clearances and Dimensions INSTRUCTIONS • Dimensions that are shown in Figure 1 must be used. Given dimensions provide minimum clearance. Locate electrical outlet in the shad- ed area in the upper left-hand corner of the cut- This appliance must be grounded.
INFORMATION YOU NEED TO KNOW Drawer Microwave Measurements Figure 2 A. 21-5/8” (549.28 mm) B. 4-11/16” (119.06 mm) C. 1-3/4” (44.45 mm) D. 21-7/8” (555.60 mm) E. 23-7/8” (606.43 mm) Figure 1 F. 15-7/8” (403.22 mm) G. 14-19/32” (370.69 mm) A.
INSTALLATION INSTRUCTIONS Anti-Tip Block Electrical Outlet The electrical requirements are a 120 volt 60 Hz, Normal Installation Steps AC only, 15 amp. or more protected electrical Anti-Tip Block Installation supply. It is recommended that a separate circuit Instructions serving only this appliance be provided. The Drawer Microwave is equipped with a 3-prong •...
INSTALLATION INSTRUCTIONS Drawer Installation Model and Serial Number Location The nameplate includes model number and serial number. Open the Drawer Microwave fully. The label is slightly beyond the back wall of the microwave cavity facing up from the flat surface. Care, Cleaning and Maintenance Refer to the Use and Care Manual for cleaning...
Page 9
TABLE DES MATIÈRES 1 INSTRUCTIONS DE SÉCURITÉ IMPORTANTES .........10 2 DÉBALLAGE DU FOUR DRAWER MICROWAVE ........11 Remarques Importantes pour L’installateur ..11 Remarques Importantes pour le Consommateur ..........11 3 CE QUE VOUS DEVEZ SAVOIR ..12 Dégagements et Dimensions......12 INSTRUCTIONS POUR LA MISE À...
INSTRUCTIONS DE SÉCURITÉ IMPORTANTES IMPORTANT - S’il vous plaît lire et suivre • ADVERTISSEMENT : Si l’on ne suit pas de près les indications dans ce manuel, il y a un • Prière de lire attentivement toutes ces direc- risque d’incendie ou de décharge électrique qui tives avant de commencer.
DÉBALLAGE DU FOUR DRAWER MICROWAVE Remarques Importantes pour • Retirez tout le matériau d’emballage du Drawer Microwave. N’ENLEVEZ PAS LE COUVER- L’installateur CLE DU GUIDE D’ONDES, qui se trouve sur le • Lisez tout le manuel d’installation avant d’in- dessus du Four Drawer Microwave. staller le Four Drawer Microwave.
CE QUE VOUS DEVEZ SAVOIR INSTRUCTIONS Dégagements et Dimensions POUR LA MISE À • Les dimensions indiquées au Schéma 1 doivent être observées. Ces dimensions offrent un dégagement minimal. Repérer la prise élec- LA TERRE trique dans l’aire ombrée dans le coin gauche supérieur de la découpe.
CE QUE VOUS DEVEZ SAVOIR Mesures pour le Four Drawer Microwave Schéma 2 A. 21-5/8 po (549,28 mm) B. 4-11/16 po (119,06 mm) C. 1-3/4 po (44,45 mm) D. 21-7/8 po (555,60 mm) E. 23-7/8 po (606,43 mm) Schéma 1 F.
INSTRUCTIONS D’INSTALLATION Bloc Anti-Basculement Prise de Courant Le courant alimentation est 120 volts, 60 Hz, CA Étap es d’insta llation norma le seulement, 15 A ou plus et doit être protégé. Il Directives d’install ation du bloc est recommandé d’alimenter cet appareil par un anti-basculement circuit séparé.
INSTRUCTIONS D’INSTALLATION Installation du Tiroir Emplacement des Numéros de Modèle et de Série La plaque d’identification comprend les numéros de série et de modèle. Ouvrir complètement le four Drawer Microwave. L’étiquette se trouve légèrement au-delà de la paroi arrière de la cavité du four à...