Software Setup; Installation Of Software - Fujitsu F2MC-8FX Series Setup Manual

5. Software Setup

In the software setup procedure, you install and operate the software applications.
This chapter includes the installing and operating procedure for each software in order. Check the
contents and complete the software setup.

5.1 Installation of Software

This section describes how to install S
how to install the sample program.
■ Installing S
OFTUNE
Follow the instruction described in "F
bench Installation Guide" to install S
■ Installing USB Driver
Plug a USB cable connected to BGM Adapter into your host computer. After you connect the host
computer and the BGM Adapter, the [Found New Hardware Wizard] window appears. Follow the
instruction below to install the USB driver.
In a few seconds after the above dialog is displayed, the [Welcome to the Found New Hardware Wiz-
ard] screen appears. Click [Next] to install the device driver.
• Installation of software
- Installing S
OFTUNE
- Installing USB driver
- Installing sample program
• Operation of S
OFTUNE
- Starting S
OFTUNE
- Starting Debugging
- Initializing MCU
- Running the program
- Aborting the program
- Ending Debugging
- Exiting S
OFTUNE
Workbench
Workbench
and the USB driver in your host computer, as well as
OFTUNE
2 MC-8L/8FX Family 8-bit Microcontroller S
in your host computer.
OFTUNE
Work-
OFTUNE
9